iGuard FPS110
P.12
Setting the Administrator Password & Access Password
iGuard FPS110 has two
“global”
passwords
2
. The
Administrator Password
is used to
access the system menu and to configure the system (such as accessing the setup
menu in the last example). The
Access Password
is useful only when the device is
configured as Access Control Mode (i.e., not configured as Time Attendance Mode).
User can use this Access Password to gain access without verifying with the
fingerprint image.
Follow these steps to assign & edit the two passwords:-
Description
LCD Display
Admin Password:
123_
1. While in Standby Mode, press the
Func
key to enter
the Setup Menu. Enter the Administrator Password
(default 123) and press
Func
key, then press
6
to
select “Set Password… ” menu.
Admin Password:
AB456_
2. Press the
backspace
to erase the old password, and
enter the new password (e.g., AB456).
Access Password:
_
3. Press the
Func
key to accept the new Administrator
Password. You will then be prompted for the Access
Password as shown.
Access Password:
9394AB709_
4. Enter the new Access Password (e.g., 9394AB709). It
is suggested to use a long and hard-to-guess password
(max 10 chars).
Mon Aug 30 13:49
ID #:_
5. Press
Func
to continue. The system will return to
Standby Mode.
Note:
You must enable the Access Password before it can be used, by specifying the
corresponding authorized time and terminals. It is disabled in the factory settings.
The only way to enable it is via the Internet Browser (discussed in later sections),
under the “
Quick Access
” page as follows: -
2
You should not confuse these Global Passwords with the Personal Password, which can be assigned uniquely
to each individual. More details about the Personal Password will be discussed in later sections.
