82
iGage
iG8 User Manual
27.
Clicking the ‘down-arrow’ will display the owner’s
name or telephone number:
28.
Down arrow to the FCC ID which is transmitted in
Morse Code (CW) every 15 minutes:
A valid FCC license is required for operation in the
United States and the FCC assigned ID must be
transmitted by continuous wave (CW) Morse Code
every 15-minutes.
29.
Press the down arrow to view the current
modulation type:
The modulation type will change based on the
selected protocol.
30.
In almost all cases for all current FCC licenses in the
United States, the channel bandwidth must be 12.5
KHz or less to meet FCC requirements:
31.
This screen indicates if the transmitter is enabled
and what the output power is:
On hot days, it is possible that the radio power
setting is higher than the enabled value. Power will
also be reduced if Antenna Detect is enabled and a
fault is detected.
32.
This is the internal temperature of the receiver:
Automatic power management becomes active
when this temperature is higher than 85 C.
33.
15-seconds after you switch to the Duty Cycle
screen, the transmit duty cycle of the receiver is
shown:
34.
This is the firmware revision currently running in the
radio:
NOTE: The current (May 2016) firmware version is
4.20. You can check for updated firmware online at
35.
Finally the regulatory region code is displayed:
Always leave this setting as shown.
Always leave this setting as shown. Do not be
concerned that it lists countries that do not include
the USA.
