IFM AC412S, Device Manual

Page: 143 / 242

SmartPLC SafeLine with PROFIBUS slave interface
143
8.7 Set the Profibus interface
41431
Detailed information on how to configure the PROFIBUS network:
→ operating instructions of
the PROFIBUS master
To integrate the device into a PROFIBUS network:
1 Set the interface parameters
► > >
►
Set the interface parameters (→ Configure the PROFIBUS interface ).
2 Integrate device into PROFIBUS project using the GSD file
► Copy the GSD file of the device to the PC/laptop with the PROFIBUS configuration software (→ Download GSD
file (→ S. 117 )).
► Load the device into the device library of the PROFIBUS configuration software by means of the GSD file
(→ operating instructions of the PROFIBUS configuration software).
► Integrate the device into the PROFIBUS project.
3 Set the device parameters, fieldbus modules and system behaviour
►
Set the following parameters in the PROFIBUS configuration software:
– Device-specific parameters (→
Device-specific parameters (→ S. 174 ))
– PROFIBUS modules (→ PROFIBUS modules: compatibility mode AC14 (→ S. 178 ))
►
Set the system behaviour in the PROFIBUS configuration software (e.g. watchdog)
4 Activate configuration
► Save and load the configuration to PROFIBUS controller (download).
►
Start the PROFIBUS controller.
> The device has been integrated into PROFIBUS network (→ Status LED of the PROFIBUS interface).
5 Display the set configuration on device
►
> >
► Select [Profibus data] tab.
> The page shows the saved configuration.
>
8.8 Setup of the configuration interface
41410
To set up the EtherNet configuration interface (X3):
► >
►
Select [IP setup] tab.
►
Set the interface parameters (→ Notes on IP settings (→ S. 110 )).