SmartPLC DataLine with Profinet device interface
81
>
5.6.1
Interfaces: Konfigurationsschnittstelle 1
41481
The [Konfigurationsschnittstelle 1] menu provides access to the settings of the Ethernet
Konfigurationsschnittstelle 1 (port X3).
>
Notes on IP settings
41751
The device provides the following options for configuration of the Ethernet Konfigurationsschnittstelle
1:
Manual =
The operator sets the interface parameters (IP address, network mask,
gateway address) manually.
Automatic =
The interface parameters are set automatically. The operator can choose
between these protocols:
– Dynamic Host Configuration Protocol (DHCP)
– Zero Configuration Networking (Zeroconf)
To display the current configuration method and the active IP parameters of the configuration
interface:
1 Select the menu page
►
>
►
Select [IP setup] tab.
2 Show the active settings
>
The parameters below show the active settings:
Parameter
Meaning
Possible values
[Optain IP address
autom.]
Active method for the
configuration of the interface
parameters
Manual assignment of interface parameters through operator
Automatic assignment of interface parameters
[IP status]
Configuration protocol used
[Static]
The operator sets the IP parameters manually.
[DHCP]
The IP parameters are set by a DHCP server.
[Zeroconf]
The IP parameters are set automatically with the
Zeroconf protocol.
[IP address]
IP address of the interface
e.g.
192.168.0.100
[Subnet mask]
Network mask of the network
segment
e.g.
255.255.255.0
[Gateway address]
IP address of the network
gateway
e.g.
192.168.0.1
►
Select one of the following options:
–
Configure the IP parameters manually
–
Configure the IP parameters automatically
(→ S.
