IEMCA VIP80 Evolution, Manual For Use And Maintenance

Page: 72 / 86

GB
7 - BAR FEEDER MAINTENANCE VIP80E
7 - Pag. 2 / 5
7.1 PRELIMINARY NOTE ON MAINTENANCE
IMPORTANT:
Before carrying out any maintenance, start all safety devices provided and
check if it is necessary to inform the staff operating around and people close to
the area. In particular, it is recommended to adequately signal the adjacent
areas and to prevent anyone from approaching all the devices that, if started,
could cause unexpected damages and harm to people.
7.2 SCHEDULED MAINTENANCE
IMPORTANT:
keep the bar feeder in conditions of maximum efficiency, carrying out the
programmed maintenance operations provided by the manufacturer. A good
maintenance will allow the best performances, a longer service life as well as a
constant keeping of safety requirements.
Frequency
Hours
Component Kind of intervention
200 500 1250 2500
Yea
rly
Check and possibly adjust
tension (section 5.5.) • Feed belt
Test wear. If necessary replace
it (section 9.3.)
•
Revolving tip Test wear (section 7.3.). If
necessary replace it (sec.9.2.).
•
Carriage unit
Lubricate the sliding guides
(section 7.4.)
•
Rack Lubricate (section 7.4.) •
Magazine Lubricate the bevel gear pair
(section 7.4.)
•
Stop device Lubricate forks and pins
(section 7.4.)
•
Bar-pushing unit
Lubricate the lifting toothed
wheels (section 7.4.). •
PLC
Replace battery (section 9.4.) •
Hand-held control Replace battery (section 9.5.) •