IEMCA VIP80 Evolution, Manual For Use And Maintenance

Page: 80 / 86

GB
9 - PART REPLACEMENT VIP80E
9 - Pag. 2 / 5
9.1 PRELIMINARY NOTE ON PARTS REPLACEMENT
Before carrying out any replacement, start all safety devices provided and check if it is
necessary to inform the staff operating around and people close to the area. In particular, it is
recommended to adequately signal the adjacent areas and to prevent anyone from approaching
all the devices that, if started, could cause unexpected damages and harm to people.
If it proves necessary to replace worn components, use only original spare parts.
We disclaim any responsibility for damages to components and injury to people derived from
the use of non-original spare parts and from any repair carried out without the manufacturer's
authorisation.
For spare parts ordering, follow the indications reported on the spare parts catalogue.
9.2 REVOLVING TIP REPLACEMENT
For replacement proceed as follows:
- Open the top cover.
- Disassemble the bar pusher, see section 6.8.
- Remove the pin (A) in order to disassemble the
revolving tip.
- Assemble the new revolving tip and insert the
new pin.
- Assemble the bar pusher again.
- Close the top cover.