IEMCA SIR 52 P, Manual For Use And Maintenance

Page: 34 / 174

EN
4 - HANDLING AND INSTALLATION SIR-52-P/F
4 - Pag. 6 / 22
4.3 INSTALLATION AREA - FEATURES
- The floor should be stable and levelled to guarantee good fastening to the ground.
- Provide an area of suitable dimensions according to the type of feeder use.
Table 2.Installation area dimensions
Models Version A (mm)
33 4950
38 5450
SIR 52 P
SIR 52 F
43 5950
- The areas: (B) (work area), (C) (bar feeding area) and (D9 (remnant discharge area) should
be properly delimited to prevent collisions between the operator and any handling equipment
or transport vehicles travelling near the bar feeder.
- The selected bar feeder setting should be suitably lit and provided with an electric power
and air outlets.
- During operation, the feeder will release small amount of oil vapors. Make sure that the
premises where the feeder is installed are suitably ventilated.
4.4 INSTALLATION
The most important phase of installation is the alignment between the bar feeder and lathe,
hence said operation shall be carried out by skilled personnel with the maximum precision.
WARNING-CAUTION:
A wrong alignment may be the main cause of bar feeder malfunctioning and may
cause damages to the machine.