IEMCA SIR 52 P, Manual For Use And Maintenance

Page: 73 / 174

5 - ADJUSTMENTS AND SETTING-UP SIR-52-P/F
EN
5 - Pag. 23 / 26
5.7.2 Clamps grip (B)
The clamps grip is the force through which clamps hold the bar during the introduction phase
into collet.
To carry out adjustment, operate knot (B).
5.7.3 Static thrust (C)
The static thrust is the force through which the bar-pusher continuously press against bars.
It operates in every station, with the exception of the loading stations.
To carry out adjustments, operate knob (C).
INFORMATION
Usually, the static thrust must remain at a value of 5 bar, therefore it does not
require any adjustment.
5.7.4 Clamps introduction force (D)
The force of introduction is the force through which the bar is introduced into the bar-pusher
collet and the bar remnant is extracted.
To carry out adjustment, operate knob (D).
5.7.5 Feeding speed (E)
The feeding speed is the speed at which the bar feeds at each lathe opening.
CAUTION:
A too high feeding speed may cause damage to lathe equipment.
A too low feeding speed may cause the collet to close before the complete feed
of bar.
To carry out adjustment, operate knob (E).