EN
6 - USE AND OPERATION
SIR-52-P/F
6 - Pag. 20 / 24
33 Remove the bar-pusher to be replaced and place the rear rotating unit into the new bar-
pusher.
34 Assemble the suitable collet by means of a standard bar remnant previously introduced into
the collet and position the new bar-pusher in the same housing of the previous bar-pusher.
35 Press the
key to lock the bar-pusher carriage.
36 Adjust the guide channel at the desired diameter by using the "Standard Operation Mode" or
the "Staggered Sprockets Operation Mode" (paragraph 5.3.).
37 Push the
button to close the guides.
38 Close the lateral case.
39 Turn the
switch in
position.
40 Press the
key to open guides.
41 Press the
key to rotate the clamp arm towards the drum.
42 Press the
key to close guides.
43 Press the
key to open the bar-pusher locking.
44 Press the
key to feed the bar-pusher; position the bar-pusher into the spindle and the
bar remnant into the collet and its relevant carriage in the bar end area.
45 Press the
key to rotate the clamp arm outside the drum.
46 Press the
key.
47 Rotate the lathe spindle of any station whatsoever up to the OPEN COLLET position.
48 Press the
key.
49 Repeat all the operations from number 21 up to number 43 in the same sequence to replace
all the bar-pushers.
50 Press the
key.
Summary of Contents for SIR 52 P
