IEMCA SIR 52 P, Manual For Use And Maintenance

Page: 94 / 174

EN
6 - USE AND OPERATION SIR-52-P/F
6 - Pag. 18 / 24
6.8 PROGRAMMING - PARAMETERS ENTRY
The entering of parameters is necessary to program the automatic cycle of the bar feeder,
according to the working requirements and to the machine type.
For more detailed instructions, see the "Push-button panel operation and instruction manual".
6.9 WORKING DIAMETER CHANGE - OPERATIONS SEQUENCE
The operations for the machining diameter change have to be done on the basis of the previous
machining and in relation to the following machining; see "COMPARATIVE TABLE OF THE
WORKING DIAMETERS" (paragraph 5.3.).
If the stock guide tube diameter has to be replaced, you need to follow the procedure explained
in paragraph 6.9.1; otherwise, follow the procedure explained in paragraph 6.9.2.
DANGER - WARNING:
During the working diameter change operations, do not open the machine doors
when it is running and do not manually turn the lathe spindles when drum guide
is open.