EN
2 - INFORMATION FOR USE
KID 80 SIV
2 - Pag. 22 / 66
no. 4 Short feeding safety
During every feeding stage, it checks that
the bar does not go further than the value
set in parameter 6 and keeps the tolerance
level set in parameter 4. Should this not
occur for any reason, when the lathe cuts
the "FEEDING" signal, the bar feeder goes
into "ALARM".
If parameter 6 is set to 0, this parameter is
not active.
A - Parameter 4
B - Parameter 6
0 - (Not enabled for first piece); the parameter is active for all feeding operations except for
the first piece.
1 - (Enabled for first piece): the parameter is active for every feeding operation (the facing
phase excepted).
INFORMATION
The short piece control cannot be performed in sliding headstock lathes (bar
feeding is carried out by the headstock).
INFORMATION:
Setting the subparameter to 1 (Enabled for first piece), the "short piece"
(parameter 4) checks are activated straight after the first piece.
4
no. 4 Short feeding
safety
xxxx (mm)
(inches)
DEFAULT VALUE
PROGRAMMABLE
VALUE
K I D
K I D
0
0
Summary of Contents for KID 80
