2 - INFORMATION FOR USE
KID 80 SIV
EN
2 - Pag. 9 / 66
2.5
OPERATOR PARAMETERS: OPERATION MODE
These parameters are needed for the bar feeder automatic cycle programming and should be
set according to the working requirements as well as to the lathe type that is connected to the
bar feeder. Some parameters concern the working phase, while others are used for the bar
change phase.
WARNING - CAUTION
The parameters are set to a default value (preset value): the bar feeder
performs the automatic cycle according to these values. Some parameters may
not be appropriate for the lathe type or the type of machining requested.
The main operation modes are listed hereunder:
- Accessing the parameters
- Parameter
display
- Parameter
modification
- Subparameter
display
- Subparameter
modification
- Exiting the parameters
Summary of Contents for KID 80
