IEMCA KID 80, Instruction Manual

Page: 76 / 126

EN
2 - INFORMATION FOR USE KID 80 SIV
2 - Pag. 54 / 66
2.12 ERRORS - CAUSES - SOLUTIONS
During the bar feeder setup or the piece machining, the display may highlight errors or
messages.
Such errors or warnings may be caused by an incorrect programming, an incorrect manoeuvre,
or a mechanical or electrical fault.
When the errors are detected the bar feeder stops; to restore the automatic cycle carry out the
following procedure:
- restore the manual cycle;
- eliminate the cause of the error;
- restore the automatic cycle.
INFORMATION
All messages with "Error" must be reset by pressing .
When a warning is displayed the bar feeder does not stop and it is not necessary to reset the
machine.
The warnings appear when attempting to perform a manoeuvre which is not allowed by the
program and provide information for the operator during the machining.
The error/warning messages, the possible causes and their solutions are shown below.