EN
2 - INFORMATION FOR USE
KID 80 SIV
2 - Pag. 36 / 66
3 - (Bar change advance no facing)
Allows the bar feeder to carry out the bar change while the lathe has started machining the last
piece. Thus, the bar change starts in advance, i.e. before the last piece machining ends and the
bar pusher attains point F. The remnant is ejected only with the new bar.
Necessary conditions.
- Set the interface signal 85 "LOADING CYCLE", in position 1 (=NC) and set parameter 21,
"REMNANT HANDLING", in mode 3.
- Use the "LOADING CYCLE" lathe signal (applicable only to lathes which have this function).
Description of the phase order:
- the lathe receives the "BAR END" signal, with the above mentioned conditions;
- the bar feeder carries out the bar pusher return, loads a new bar in the guide channels,
carried out first feeding and bar loading in the bar feeder collet and then awaits the
"FEEDING" and "BAR CHANGE" signals;
- as soon as the last piece has been machined, the lathe enters the subprogram (bar stop
removal) and sends both the "BAR FEEDING" and "BAR CHANGE" signals;
- the new bar begins the facing phase until it reaches the position indicated in parameter 2,
the bar feeder sends the cycle start signal to the lathe.
no. 22 Open collet timeout
This is the maximum duration time of the
FEEDING phase ("OPEN COLLET").
If for any reason the bar feeder remains
with the feeding enabling signal ("FEEDING"
signal from lathe) for a longer time than the
set one, it goes in "ALARM".
22
no. 22 Open collet
timeout
xxxx (sec)
DEFAULT VALUE
PROGRAMMABLE
VALUE
K I D
K I D
0
0
Summary of Contents for KID 80
