MSD-501/502/701/702 User
’s Guide
97
7.15.9 Input image capture
Menu Top
→
BITMAP
→
VIDEO CAPTURE
Setting value
Setting item
Setting value
Default
Output channel
OUT1,OUT2
OUT1
Register number
No.1 to No.4
No.1
An input video can be treated as a bitmap by capturing the input video. The maximum resolution has to be
[Horizontal resolution x Vertical resolution x 3 (the number of bytes per pixel; “3” is fixed)] = 8,388,608 bytes or
less. If you register several bitmaps and captured video, the total resolution of all bitmaps and captured videos
has to be 8,388,608 bytes or less (aspect ratio does not matter).
Captured images can be displayed in the same size or enlarged size but not in the reduced size. Larger
resolutions require a longer writing time ; it may take approximately six seconds at a maximum to write a
bitmap. Register images with lower resolution than that of the sink device. (If an input image is larger than the
output image, capture it with reduced image size. If an input image is the same size or smaller, capture the
image
without changing its size. You can register images with lower resolution by setting “
” to smaller value and capture the images.)
To freeze the input video
temporarily, press the “MENU/SET” key. To register the frozen video, select “YES”
and
then press the “MENU/SET” key again. To release freeze, press the “ESC” key. It can be released
automatically when an input is switched or input signal changes.
If resolution of input video is too large against the reserved memory area and it causes a memory shortage, a
message
“MEMORY SIZE OVER” will be displayed after you press the “MENU/SET” key. In such a case,
registration will not be executed.
From browser
You can save input video captured via a WEB browser, such as Microsoft Internet Explorer.
Open the WEB browser on a PC using the same LAN and enter the IP address of the MSD followed by
“/capture.html” to open the window for capturing images.
【
See:
7.12.1 IP address/subnet mask/gate way address
【
[Table 7.23] Input example
Port number for WEB browser
Input example in address bar
80 (normal)
http://192.168.1.199/capture.html
Other than 80 (5000 to 5999)
http://192.168.1.199:5000/capture.html (example: 5000)
When an IP address is entered, the following window will be displayed. Use the window to send the bitmap
file.
When the bitmap file is sent correctly, the message,
“BITMAP SAVE NOW PLEASE WAIT” is displayed on
the VFD screen and the bitmap file is being saved. Do not turn off the MSD while the message is displayed.
If the bitmap file is not send correctly, an error message below will be displayed.
