IDK MSD-501, User Manual

Page: 66 / 120

MSD-501/502/701/702 User
’s Guide
66
7.11 RS-232C communication setting
The RS-232C connector of the MSD can output communication command control from PCs and can output
control command to external devices from the MSD. The operation mode will be switched according to
“
7.11.2
Operation mode
”.
The RS-232C connector of HDC receiver that is connected to digital signal output connector for extension
only can output control command to external devices.
Communication between the RS-232C connector of the MSD and the RS-232C connector of the HDC
receiver that is connected to a digital signal output connector for extension can be performed by the setting of
“
7.11.3RS-232C
”.
【
See: 7.13 Setting control command
】
Rx
R
S
-2
3
2
C
L
A
N
FG
D
C
5
V
2
A Cat6 Rx for HDMI
HDC-RH100-C
OPTION
RS-232C
OFF ON
OPTION
RS-232C
OFF ON
OPTION
RS-232C
OFF ON
IN
P
U
T
DON'T
CONNECT
LAN
H
DC
CAUTION
!
O
U
T PU
T
(M
A
X 2
M
)
H
DM
I
POWER LINK HDCP STATUS POWER LINK HDCP POWER LINK HDCP STATUS
Lap top
Projector
RS-232C cable
Twisted pair cable RS-232C cable
Power amplifier
Communication command control
to MSD
Control command output to
external device
HDC receiver
Control command output to external device
Not connected (RS-232C connector works normally)
RS-232C transmission setting between control
devices (OUT B SCI CONNECT)
RS-232C
LAN
UPDATE
AUDIO OUT 2 AUDIO OUT 1
R L R L
R L R L R L R L R L R L R L
AUDIO IN 7 AUDIO IN 6 AUDIO IN 5 AUDIO IN 4 AUDIO IN 3 AUDIO IN 2 AUDIO IN 1
AC 100-240V 50Hz / 60Hz (FUSE T2.5A 250V)
ANALOG RGB / YPbPr / VIDEO
IN 6
ANALOG RGB / YPbPr / VIDEO
IN 7 IN 3 IN 4 IN 5
HDMI / DVI / ANALOG
HDMI / DVI HDMI / DVI
IN 2
HDMI / DVI
OUT 1 OUT 2
HDMI / DVI HDMI / DVI
LINK
B
OUT 2
HDC
LINK
B
OUT 1
HDC
A A
FG
[Fig. 7.14] RS-232C communication
7.11.1 RS-232C communication
Menu Top
→
COM PORT
→
PARAMETERS
Setting for Each RS-232C connector, OUT1B connector, OUT2B connector
Setting value
Setting item Setting value Default
Baud rate [bps] 4800, 9600, 19200, 38400 9600
Data bit length [bit] 8, 7 8
Parity check NONE, EVEN, ODD NONE
Stop bit [bit] 1, 2 1
You can set RS-232C communication.
The setting of this menu is not updated until the MENU/SET key is pressed. Make sure to press the
MENU/SET key to update the setting.