MSD-501/502/701/702 User
’s Guide
42
7.6.3 Input equalizer
Menu Top
→
INPUT SETTING
→
INPUT EQUALIZER
Setting for Each input (only digital input)
Setting value ON [Default],OFF
HDMI input connector has an equalizer circuit to correct attenuated signal caused when a long cable is
connected. If you set this menu to “ON”, signal is corrected automatically according to the amount of the
attenuation. However, if you connect a cable booster or the like for input of the MSD, compensatory functions
may sometimes conflict and signal cannot be corrected appropriately. In such a case, set this menu to
“OFF”.
7.6.4 Signal type of analog input
Menu Top
→
INPUT SETTING
→
ANALOG INPUT TYPE
Setting for Each input/input signal (only analog input)
Setting value
・
AUTO : Automatic [Default]
・
VIDEO AUTO : Video automatic
・
RGB
: Analog RGB
・
VIDEO
: Composite video
・
YPbPr : Analog YPbPr
・
Y/C
: S video
You can set the signal type that is input from the analog video input connector.
If you select “AUTO”, the type of input signal is detected automatically. In cases where the detection fails and
video is not output correctly, set the input type manually. With “AUTO”, the automatic detection of S-Video
may fail. If both composite video and S-Video are input at the
same time, select “VIDEO AUTO”; if only
S-
Video is input, select “Y/C”.
For video of a monochrome camera or VHS tape with a bad recording condition or the like, automatic
detection may fail. In these cases
, select “VIDEO AUTO”, “VIDEO” or “Y/C”.
