Page 6 -
Tunnel Master® Jr. User Manual
Chapter 2: Hardware Installation
Low Voltage Layout
LOW VOLTAGE LAYOUT
*** THIS DRAWING IS NOT TO SCALE. THIS DRAWING IS MEANT ONLY TO
SHOW THE TYPES OF WIRING THAT MUST BE RUN BETWEEN PIECES OF ICS
EQUIPMENT. THE INDIVIDUAL RUNNING THE WIRING MUST ENSURE THAT
AMPLE WIRE IS AVAILABLE AT EITHER END TO FACILITATE TERMINATION.
THE TERMINATION POINTS OF THE CABLES ARE NOT SHOWN ON THIS
DOCUMENT.***
CONTROLLER
KEYPAD
ICS SUPPLIED 24/4
SHIELDED COMM
CABLE ONLY
TUNNEL MASTER JR.
RELAY BOX
SERVER
COMPUTER
NETWORK CABLE
Initialize and Clear Settings
Reset the default configuration of the Tunnel Master® Jr.
NOTE:
For first time use, ICS recommends a complete initialization and clear
the factory settings.
The Tunnel Master® Jr. is delivered with preloaded settings. You can erase these settings before
configuring your own settings. This is also known as performing an initialize and clear. The
following procedure shows how to erase the current settings:
1. Open the Tunnel Master Jr. door.
2. On the inside of the Tunnel Master Jr. door, remove the motherboard cover, if necessary.
3. Locate DIP switch 6, and then slide the switch up to the On position.
4. Press the
Reset
button located above the battery.
5. On the Tunnel Master Jr. (TMJ) display, press the
Menu
button.
6. On the display keypad, press
#1
.
The TMJ display quickly flashes the “Initialize Files” message.
7. On the display keypad, press
#2
.
The TMJ display quickly flashes the “Clear Memory” message.
Figure 2-1. Low Voltage Layout
Summary of Contents for Tunnel Master Jr
Page 1: ...Tunnel Master Jr User Manual Version 5 0...
Page 70: ......