Firmware Version 1.2
MultiSystem 4070
35
Operation
DEU
Connect a PC and transfer data
1
Switch on measuring instrument and PC.
2
Make sure that “Mass storage device” is selected as USB mode and that
at least one volume is enabled.
See
3
Plug the supplied USB cable into the connector on the side of the measur-
ing instrument.
4
Plug the USB cable into an available USB jack on your PC.
System requirements for your PC:
• Windows 7/8 (driver required)
www.hydrotechnik.com
• Windows 8.1 or later
5
Wait until the measuring instrument has been detected by the PC.
6
Perform the data transfer as described in the software documentation.
The internal memory has two partitions:
•
DATA-VOL
This is the general memory for files (measurement series, images, etc.)
•
DOCU volume
This is where you will find the operating instructions, data sheets and soft-
ware for this instrument.
You have to install the software
HYDRO
com
on your PC, before you can transfer
measurement data to your PC.
Data transfer with micro USB cable
The measuring instrument is recognized as a removable storage device. You can
therefore open the operating instructions directly from the instrument.
If the measuring instrument is not recognized, this may be due to the USB cable
you are using. Use a micro USB Type B cable that supports the “data transfer”
function.