![background image](http://html.mh-extra.com/html/icom/ic-207h/ic-207h_instruction-manual_611992023.webp)
3
SETTING A FREQUENCY
18
■
Tuning step selection
Tuning steps are the minimum frequency change increments
when you rotate the tuning dial or push the [
Y
] or [
Z
]
switches on the microphone. The following tuning steps are
available:
• 5 kHz
• 10 kHz
• 12.5 kHz
• 15 kHz
• 20 kHz
• 25 kHz
• 30 kHz
• 50 kHz
NOTE:
For convenience, select a tuning step that
matches the frequency intervals of repeaters in your area.
➀
Push [BAND] to select the desired band, if necessary.
➁
Push [V/MHz] to select VFO mode if another mode has
been selected.
➂
Push [SET] one or more times until “tS” appears as shown
below.
• Pushing [MONI] reverses the order of selection.
• Cancel the DTMF memory function in advance. (p. 48)
➃
Rotate the tuning dial to select the tuning step.
➄
Push [V/MHz] to exit set mode.
Ä
Push [BAND] to select the operating band, if
necessary.
Å
Push [VFO] to select VFO mode.
Ç
Push [
F
SET] one or more times until “tS” ap-
pears as shown previously.
• Push [ENT] to reverse the order of selection.
• Cancel the DTMF memory function in advance.
(p. 48)
É
Push [
Y
] or [
Z
] to select the tuning step.
Ñ
Push [CLR] to exit set mode.
USING
SET MODE
25 kHz tuning step
15 kHz tuning step
H I
1
9
5
H I
1
9
5
SET
B