ICETEAM 1927 SL193-011342, Electronic Manual

Page: 32 / 58

SL193-011342 ED00 10-2018 29
Alarm Description
Check of the table of the lack of power in PRODUCTION.
The event is memorized in any function and memorized in the
events.
Timeout Prd. In PRODUCTION, the beater motor activation time is controlled.
If this stays ON for 10 minutes (Timeout Prd.) without reaching
HOT, the machine goes on to the status "Hot reached" with
alarm “ Timeout Prd .” In the events. The timer is reset to
MIR and when turning on MA. Control the cylinder mix load, the
pump in the tray and the cooling device.
No more cones The display shows Mix out when the level of the mix is
uncovered.
When the level is uncovered and in PRODUCTION a number of
cones equal or higher than the value established in step Last
cones is supplied, in addition to viewing the message Mix Out,
the machine will go on to the status of Hot reached,
deactivating all the exits in the side in which the cones have
finished.
Why in STOP? If the machine is left on STOP with level uncovered, after 30" the
flashing message (and display) "
Why in STOP?
" is shown
and a flashing acoustic warning is produced. This wars the user
that it is necessary to place the machine in PRODUCTION or
Store. The message is removed by entering in PRODUCTION or
uncovering the mix level or pressing on the RESET (Cons.) key.
For the message to appear again, PRODUCTION or STORAGE
have to be turned on again.
Close Handle In PRODUCTION, indicates that the MIR has been
Working for more than 15". In this case, it is necessary to remove
a cone by pulling the handle at the end of the run and closing
it again.