IC Bus CE Series 2020, Operation And Maintenance Manual

Page: 75 / 287

Driver Controls
2. Bring the vehicle to the desired operating speed (above
35 mph [56 km/h]), and then push the SET / CRUISE
position of the steering wheel control.
3. Once in the cruise mode the right side SET / CRUISE
– RESUME / ACCEL switch can be used to increase
or decrease vehicle speed by pressing and holding the
RESUME / ACCEL to increase or the SET / CRUISE to
decrease vehicle speed.
4. A slight tap on the brake or clutch pedal will deactivate
the cruise but holds the selected speed in memory. To
return to this speed, just press RESUME / ACCEL.
5. When you press the OFF (left) position of the CRUISE /
THROTTLE - ON / OFF switch, or if the vehicle is shut
OFF, the selected speed setting is canceled.
Throttle
This feature is ordered to provide variable engine speed control
primarily for operation of PTO powered equipment. It uses the
same Cruise controls as described below.
1. Press the CRUISE / THROTTLE - ON / OFF steering
wheel control to ON.
2. Press SET / CRUISE on the steering wheel control.
3. Press and hold RESUME / ACCEL to increase engine
speed until the desired engine speed is obtained. Or,
you can repeatedly press and release RESUME /
ACCEL to increase the speed in small increments.
4. To change from this initial setting, use the appropriate
control to raise or lower the engine speed as you would
in the cruise control mode. SET/CRUISE reduces
engine speed and RESUME / ACCEL increases engine
speed.
5. Press the OFF position of the ON / OFF control to turn
the throttle off and return the engine to idle.
Stationary Variable Speed Control (12VXT)
This feature is ordered to provide variable engine speed control
primarily for operation of PTO powered equipment. It operates
the same as the Cruise / Throttle controls discussed above.
Stationary Pre-Set Speed Control (12VXU)
1. To activate this feature, press the ON position on the
left-side CRUISE / THROTTLE - ON / OFF switch.
2. When ordered, this feature can provide two different
predetermined speeds, which are selected with the SET
/ CRUISE or RESUME / ACCEL positions. You need to
know which position to use for your specific operation.
Press the right side SET / CRUISE or RESUME / ACCEL
switch for the desired pre-set speed.
3. First, press the switch that selects one of the desired
speeds.
4. To select the other speed, press the other switch. The
engine will immediately return to idle.
5. You must push the switch a second time to go to the
second speed. This is done to protect equipment from
being inadvertently operated at the wrong speed.
61