IC Bus CE Series 2020, Operation And Maintenance Manual

Page: 249 / 287

Maintenance Intervals and Specifications
Lubrication and Maintenance Interval: Bus – CE (Diesel) (cont.)
System Item Intervals Special Interval (3) : miles (km) / hours / months
ABS Sensors - Reseat A, B
Alternator-Starter-Battery – Check B
Electrical lines routing and clipping (lines are not tangled,
crimped or pinched or rubbing against surfaces); not
spliced or taped; insulation not cut, cracked, chafed or
worn. – Inspect
B
Engine Start and Gauge / Warning Lights – Check A, B
Instrument Readings Proper – Check A, B
Electrical
Power Distribution Center: Corrosion throughout case and
on pins of fuses and breakers – Inspect
B
Power Steering Filter – Replace 500,000 (800,000) / 1,5000 / 60
Power Steering Fluid – Change 40,000 (64,000) / – / 12
Power Steering Fluid – Check Level A, B
Steering Gear – Lubricate
A, B
ATTN: Install grease slowly at low pressure. Power
grease guns may blow out seals.
Steering Intermediate Shaft U-Joints / Slip Joint – Lubricate A, B
Steering System – Check Tightness A, B
Steering
Steering Intermediate Shaft U-Joints – Retorque 60,000 (96,000) / 1,500 / 24
Drive Shaft SPL U-Joints – Lubricate; Slip Joint Boot – Inspect B
Drive Shaft Non-booted
Slip Joint
U-Joints and Slip Joint – Lubricate
5,000 (8,000) / – / 3
235