Maintenance
1.
Inlet lid
2.
Hold-down latch
3.
Air cleaner housing
NOTE: Be careful not to bump the air filter element while it is
in the housing; this can raise a cloud of dust that can enter
the clean side of the piping to the turbocharger.
1.
Unhook the hold-down latches and remove the inlet lid
from air cleaner housing. Remove the filter element
carefully and slowly, then discard the old element.
2.
Wipe the inside of the air cleaner housing with a clean,
damp cloth. Be sure to clean the gasket sealing surface.
Be sure to wipe out any dust that has fallen into the port
to the turbocharger. DO NOT use compressed air for
this cleaning!
3.
Visually inspect the air cleaner housing for damage or
distortion, which could allow unfiltered air to enter the
engine. Inspect to be sure that the rubber dust unloader
valve at bottom of housing is in place, free of debris, and
not cracked.
4.
Inspect the new air filter element for a damaged or
nonresilient rubber gasket. Inspect the air filter element
body for dents or excessive pleat bunching. If any of
the mentioned conditions exist, obtain and install an
alternate new air filter element from your International
dealer.
205
Summary of Contents for CE Series 2020
