Passenger Control
Snooze Mode
This function allows the driver to temporarily disable the No
Student Left Behind system activation, and is called the Snooze
mode. The purpose is to allow passengers to disembark the
vehicle without the No student Left Behind system triggering the
vehicle alarm.
This alternate operation allows the driver to turn OFF the engine
while passengers enter or leave the vehicle.
Snooze Mode Initiation Procedure.
To initiate the Snooze
feature, proceed and observe the following:
1.
First, with the engine turned OFF, place the ignition
switch to the ON or ACC position.
2.
Press and release the SNZ / NO STDNT LEFT switch to
the SNZ position.
3.
The switch indicator will turn ON, indicating that the
Snooze mode is active. This places the (No Student
Left Behind) system in Snooze (inhibits triggering of
the vehicle alarm) for a predetermined time (default 20
minutes).
4.
In the last 60 seconds of the timed Snooze period, the
switch indicator will begin to flash, and will continue to
flash for the remainder of the time period.
5.
After the Snooze period, the switch indicator will turn
OFF, and the No Student Left Behind system will be
re-activated.
NOTE: The Snooze function can be turned OFF, before the
snooze time-out period, by placing the ignition switch to the
OFF position.
BUS-SCAN
®
100 System
On the BUS-SCAN
®
100 System control box, verify that the
system is in the ACTIVE mode and that the RED active LED is
illuminated with the ignition switch in the ON position.
86
Summary of Contents for CE Series 2020
