IBM System x3200 M3, Service Manual

Page: 239 / 282

5. Install the eight screws (seven in front and one in rear) that secure the system
board to the chassis.
6. Install any of the following components that you removed from the system
board:
v
The fan connector covers.
v
Hypervisor key (see “Installing a USB embedded hypervisor flash device” on
page 180).
v Virtual media key (see “Installing the virtual media key” on page 182).
v
SAS/SATA controller (see “Installing a ServeRAID-BR10il v2 SAS/SATA
controller” on page 205 ).
v Battery (see “Installing the battery” on page 184).
v
DIMMs (see “Installing a memory module” on page 169).
v Microprocessor and fan sink (see “Installing a microprocessor and fan sink”
on page 211).
v
Adapters (see “Installing an adapter” on page 152).
7. Press and hold the retaining tab on top of the cage; then, rotate the drive cage
into the chassis until it locks into place.
8. Reconnect any cables to the system board that you disconnected during
removal.
9. Install the side cover (see “Installing the side cover” on page 146).
10. Lock the side cover if you unlocked it during removal.
11. Reconnect the external cables and power cords; then, turn on the attached
devices and turn on the server.
Chapter 5. Removing and replacing server components
219