IBM System Storage TS7650G 3958 DD4, Installation Roadmap Manual

Page: 143 / 232

Important: The addresses in the summary above are examples. Actual values
will vary. For example, if the Target Network Address for the destination
server is 10.11.194.75, its starting address would be 10.11.194.0. For the Local
Gateway Address you would use the gateway address of the source server
(this server).
The Available Options prompt displays a second time:
Available Options:
==================
(a)dd a new record
(e)dit a record
(d)elete a record
(c)ommit changes
(q)uit
Please Choose (a,e,d,c,q):
8. Type:
a <enter>
.
You are prompted for the information for the second destination (target -
eth11) server and the local network.
Attention:
Do not configure the replication ports eth7 and eth11 on the same
subnet as the external LAN port Eth0. Doing so may cause replication errors.
9. At each prompt, type the requested information and then press <enter>:
Please provide the following information:
Target Network Address:
(starting network address) (for example: 10.11.196.0)
Target Network Netmask:
(for example: 255.255.255.0)
Local Gateway Address:
(the gateway IP address of the server you are currently configuring) (for
example: 10.11.197.0)
An updated summary displays:
Table 38. Example updated summary of both servers and local networks
ID
Target Network
Address
Target Netmask
Local Gateway
Address
1 10.11.194.0 255.255.255.0 10.11.195.1
2 10.11.196.0 255.255.255.0 10.11.197.1
Important: The addresses in the summary are examples. In this instance the
term target refers to the network address of the nodes at site 1 and site 2.
Actual values will vary.
For reference, write the actual values from the summary screen in the blank
spaces below.
Depending on your replication configuration, the "remote node" Target
Network Address may be the same network starting address for Server A and
B if more than one node is replicating to a single node.
Chapter 8. Configuring ProtecTIER using ptconfig
105