IBM System Storage TS7650G 3958 DD4, Installation Roadmap Manual

Page: 142 / 232

5. When you have returned to the command prompt, define the static routes
used for replication. Enter the command:
./ptconfig -staticRoutes <enter>
The message below displays:
Gathering System information [ Done ]
The auto-detected system information displays. For example:
Table 36. Example auto-detected system information
ID
Target Network
Address
Target Netmask
Local Gateway
Address
1 10.11.194.0 255.255.255.0 10.11.195.1
2 10.11.196.0 255.255.255.0 10.11.197.1
Important: This information is only an example. The information that
displays will be specific to your system, and will be different.
Followed by the Available Options prompt:
Available Options:
==================
(a)dd a new record
(e)dit a record
(d)elete a record
(c)ommit changes
(q)uit
Please Choose (a,e,d,c,q):
6. Type: a <enter>
You are prompted to enter information for the first destination (target - eth7)
server and the local network.
Attention:
Do not configure the replication ports Eth7 and Eth11 on the
same subnet as the external LAN port Eth0. Doing so may cause replication
errors.
7. At each prompt, type the requested information and then press <enter>:
Attention: In this step, the term "target" refers to the remote node's network
address and netmask (not necessarily the replication "target" server for this
entry.)
Please provide the following information:
Target Network Address:
(starting network address) (for example: 10.11.194.0)
Target Network Netmask:
(for example: 255.255.255.0)
Local Gateway Address:
(the gateway IP address of the server you are currently configuring) (for
example: 10.11.195.1)
A summary displays:
Table 37. Example summary for first server and local network
ID
Target Network
Address
Target Netmask
Local Gateway
Address
1 10.11.194.0 255.255.255.0 10.11.195.1
104
IBM System Storage TS7600 with ProtecTIER: Installation Roadmap Guide
|
|
|
|
|
|