IBM System Storage TS7650G 3958 DD4, Installation Roadmap Manual

Page: 65 / 232

Table 7. Clustered gateway installation checklist (continued)
U
Task Description Where to find information
h
1–5b For OST, up to fifteen IP addresses were
assigned for use:
v One for 3958-DD4 Server A
v One for 3958-DD4 Server B
v One for the TSSC
v Up to twelve for the OST host network
Customer
h
1–6
One or more PCs on the customer's local area
network (LAN) are designated as ProtecTIER
Manager workstations. Customer
h
1–7 A separate USB keyboard and graphics-capable
monitor have been provided for use during
installation. Customer
h
1–8
If applicable, ensure that replication
configuration efforts are being coordinated
between the source and destination sites. Customer, LBS, and or trained ProtecTIER
specialist.
Section 2: Install the gateway components
h
2–1 Have the customer suspend all I/O activity.
Power-off any components that are
powered-on, and shut down power to the
frames. Refer to the component-specific documentation
for power-off instructions.
h
2–2 Install the WTI network power switch. “Installing the WTI network power switch” on
page 31.
h
2–3 Install the 1 GB Ethernet switches. “Installing the 1 Gb Ethernet switches” on page
33.
h
2–4 Install Server A (the bottom server). “Installing the server” on page 30
h
2–5 Install Server B (the top server). “Installing the server” on page 30
h
2–6a If the customer purchased a new TSSC and
TSSC Ethernet switch, and has not yet installed
them, do so now, and then go to task 3-1. The TSSC Maintenance Information (MI),
provided on the IBM System Storage TS7650
with ProtecTIER Publications CD.
h
2–6b If the customer has an existing TSSC (with FC
2719) and Ethernet switch that can be used
with the gateway, go on to task 3-1. N/A
Section 3: Apply cable labels and make cable connections
h
3–1 Label and connect one of the power cords on
the WTI network power switch to the PDU. “Cabling a clustered gateway” on page 49.
h
3–2 Label and connect the power cord on each 1
GB switch to the PDU. “Cabling a clustered gateway” on page 49.
h
3–3
Label and connect the remaining power cords
on the WTI network power switch to the
servers. “Cabling a clustered gateway” on page 49.
h
3–4 If you installed a TSSC, label and connect the
power cord on the TSSC to the PDU. “Cabling a clustered gateway” on page 49.
h
3–5 If you installed a TSSC Ethernet switch, label
and connect the power cord on the switch to
the PDU. “Cabling a clustered gateway” on page 49.
Chapter 4. Installing the TS7650G hardware
27
|||
|
|
|
|
|
|