IBM System Storage TS3100, Setup, Operator, And Service Manual

Page: 257 / 375

3.
Slide the magazine back into the rack.
4. After the accessor runs through the inspection, a REMOVE SLOT
RESTRICTION? message will appear on the main menu screen.
5. Choose the YES option. You can replace the empty cell with a data cartridge.
Replacing a Power Supply
1. Power OFF the library by pressing and holding down the power button for 4
seconds.
2. Disconnect the power cord from the electrical source, then from the library.
3.
Loosen the three blue captive thumbscrews on the power supply located on
the back panel of the library.
4. Pull on two of the thumbscrews to pull the unit away from the rear panel of
the library, then grasp the top and bottom edge of the power supply and pull
it out of the library.
a77ug168
Figure 10-11. Popping the Slot Blocker out of the Cell
Chapter 10. Check, Adjust, Remove, and Replace
10-11