IBM System Storage TS3100, Setup, Operator, And Service Manual

Page: 288 / 375

1
Connection card screws
2
Plastic cover
3
Connection card
4
Screws that hold the drive brick to the sled (2 on each side)
5
Signal cable
6
Power cable
7
RS-422 cable
a. Remove the three screws (
1
) securing the connection card
3
) to the sled.
b.
Remove the plastic cover (
2
) from the connection card.
c. Carefully move the connection card to one side. DO NOT UNPLUG ANY
CABLES CONNECTED TO THE CARD.
4. Remove the drive brick from the sled by performing the following steps:
a. Remove the four screws (two on each side of the sled
4
) that secure the
sled to the drive brick.
Figure A-2. Drive connection card showing screws and plastic cover
A-4
TS3100 Tape Library and TS3200 Tape Library Setup, Operator, and Service Guide