IBM System Storage TS3100, Setup, Operator, And Service Manual

Page: 162 / 375

Configure Library: Network
This page shows the current network configuration of the library and allows
modification to the configuration. When a change is requested, a pop-up box
checks confirms the request.
1. Click Network in the left navigation pane, to display the Network page.
Important: Do not click the Submit button until all changes have been made
to the Network page. Once the Submit button has been clicked, no
other changes can be made until after the library has applied the
current changes.
After the Submit button has been clicked, depending on the
changes made, you will either be disconnected and need to login
again or reboot the library.
Clicking the Refresh button will refresh the page and any changes
made will not be retained.
2. Select a Protocol Stack - Choose IPv4 only , IPv6 only , or Dual Stack IPv4 &
IPv6 .
If you choose Dual Stack IPv4 & IPv6 , you must be prepared to enter both
IPv4 and IPv6 IP addresses. The sections below will gray out depending on
the choices made here.
3.
Enter the Host Name .
a77ug07
4
Figure 5-44. Configure Library: Network Page
5-52
TS3100 Tape Library and TS3200 Tape Library Setup, Operator, and Service Guide