IBM System Storage TS3100, Setup, Operator, And Service Manual

Page: 13 / 375

Figures
1-1. Front panel of a 2U library . . . . . . 1-1
1-2. Front panel of a 4U library . . . . . . 1-1
1-3. Rear panel (drive sled only) of a half high
Fibre Channel drive .
. . . . . . . . 1-3
1-4. Rear panel of a 4U library with full high
Fibre Channel drive and half high SAS
drives
. . . . . . . . . . . . . 1-3
1-5. Rear panel of a 2U library with a full high
dual port SAS drive .
. . . . . . . . 1-3
1-6. Library drive sled without ESD springs
(SCSI sled shown)
. . . . . . . . . 1-9
1-7. Library drive sled with ESD springs [1]
(SAS sled shown)
. . . . . . . . . 1-9
2-1. Power-ON screens . . . . . . . . . 2-2
2-2. Web User Interface login page . . . . . 2-6
2-3. 2U library System Status screen . . . . . 2-6
2-4. 4U library System Status screen . . . . . 2-6
2-5. 4U library System Status screen showing
media attention status .
. . . . . . . 2-7
2-6. 4U library System Status screen showing a
power supply failure
. . . . . . . . 2-7
3-1. Configuration of a one - partition system 3-4
3-2. Configuration of a two - partition system 3-5
3-3. Configuration of a three - partition system 3-5
3-4. Configuration of a four - partition system 3-6
3-5. Examples of SCSI element addressing 3-6
4-1. Installing foot pads on the bottom of the
library enclosure .
. . . . . . . . . 4-4
4-2. Shipping lock and label . . . . . . . 4-5
4-3. Library shipping lock and label storage
location .
. . . . . . . . . . . . 4-5
4-4. Rack Kit A mounting hardware . . . . . 4-6
4-5. Rack Kit B mounting hardware . . . . . 4-7
4-6. Examples of EIA units for round hole and
square hole installations
. . . . . . . 4-8
4-7. Rear view of Rack Kit A which shows the
narrow part of the rail located at the rear of
the rack..
. . . . . . . . . . . . 4-9
4-8. Rear view of Rack Kit B shows a different
mounting method
. . . . . . . . . 4-9
4-9. Kit A (top picture with circles) showing
rails installed. Rack Kit B is below showing
the front view of this kit installed.
. . . 4-10
4-10. 2U library rack anchors and mounting
brackets
. . . . . . . . . . . . 4-11
4-11. Close-up view of mounting of the anchors
on both sides of the library .
. . . . . 4-11
4-12. 2U library side screws to remove 4-12
4-13. Sliding the 2U library into the rack 4-12
4-14. Sliding the 4U library into the rack 4-13
4-15. Securing the 2U library to the rack 4-13
4-16. Securing the 4U library to the rack 4-14
4-17. Attaching a SCSI host interface cable to the
2U library .
. . . . . . . . . . . 4-15
4-18. Attaching host interface cables to the 4U
library .
. . . . . . . . . . . . 4-15
4-19. Attaching a SAS interface cable to the 2U
library .
. . . . . . . . . . . . 4-15
4-20. Interposer installation . . . . . . . . 4-16
4-21. Removing the protective label from the
power receptacle
. . . . . . . . . 4-17
4-22. Log in screen on the Web User Interface 4-21
4-23. The 2U library Configure Library: General
screen .
. . . . . . . . . . . . 4-23
4-24. Example: The 4U library Configure
Library: General screen .
. . . . . . 4-24
4-25. The 4U library Configure Library: Logical
Libraries page .
. . . . . . . . . 4-25
4-26. The Configure Library: Path Failover
Feature Activation screen.
. . . . . . 4-25
4-27. Feature Key verification screen . . . . . 4-25
4-28. Feature Activation Key screen . . . . . 4-27
4-29. Configure Library: Encryption Activation
screen .
. . . . . . . . . . . . 4-27
4-30. The Configure Library: Drive screen 4-29
4-31. Configure Library: Network Page 4-30
4-32. Warning Screen . . . . . . . . . . 4-31
4-33. The Configure Library: User Access screen 4-32
4-34. The Configure Library: Date and Time
screen .
. . . . . . . . . . . . 4-33
4-35. The Configure Library: Logs and Traces
screen .
. . . . . . . . . . . . 4-33
4-36. The Configure Library: Email Notification
screen .
. . . . . . . . . . . . 4-34
4-37. Configure Library: SNMP Page 4-34
4-38. 2U library left magazine . . . . . . . 4-38
4-39. 2U library right magazine . . . . . . 4-38
4-40. 2U library I/O Station in the left magazine 4-39
4-41. 4U library left magazines. . . . . . . 4-39
4-42. 4U library right magazines . . . . . . 4-40
4-43. 4U library I/O Station in the lower left
magazine .
. . . . . . . . . . . 4-40
4-44. Finger Holes on back side of 4U Library
I/O Station .
. . . . . . . . . . 4-41
5-1. 2U Library Control Keys . . . . . . . 5-8
5-2. 4U Library Control Keys . . . . . . . 5-8
5-3. Operator Control Panel Menu Tree 5-10
5-4. Monitor: Library menu . . . . . . . 5-11
5-5. Monitor: Drive menu . . . . . . . . 5-13
5-6. Example of a 4U Monitor: Inventory menu 5-15
5-7. Overview of inventoried cartridges: Left
magazines of a 4U Library .
. . . . . 5-15
5-8. Detailed information on cartridges residing
in a magazine
. . . . . . . . . . 5-16
5-9. Control: I/O Station menu . . . . . . 5-16
5-10. Control: Move Cartridges menu 5-17
5-11. Control: Magazine menu . . . . . . . 5-18
5-12. Control: Re-Inventory menu. . . . . . 5-18
5-13. Configure: Logical Libraries menu 5-19
5-14. Configure: Library menu . . . . . . . 5-20
5-15. Configure: Drive menu . . . . . . . 5-23
5-16. Configure: Network menu . . . . . . 5-24
© Copyright IBM Corp. 2007, 2012
xi
|
||