IBM Nways 2216, Service And Maintenance Manual

Page: 70 / 168

Setting the Supervisory Password
If a supervisory password is set, the password must be entered prior being able to
access to the “System Management Services.” You must set a supervisory
password before operational code can be loaded in the IBM 2216. The IBM 2216
is initially shipped with a password of 2216. This utility allows you to set and
change the password.
This function can be performed only if done immediately after switching the power
on.
1
Select 2. Set Supervisory Password from the utilities panel. The Set
Supervisory Password panel is displayed (Figure 4-8).
2
Type your new password and press Enter. You are prompted to enter your
new password again.
Note: The supervisory password can consist of from 1 to 8 characters with
no restrictions on which characters can be used.
‡@ —
Nways System Firmware
Version 1.0
(C) Copyright IBM Corporation, 1996 All Rights Reserved.
System Management Utilities
Select one:
1. Set Power-On P+--------Set Supervisory Password----------+
2. Set Supervisor|
|
3. Enable Unatten| Type your new password, and then |
4. Disable Unatte| press Enter. |
5. Remove Power-O| |
6. Remove Supervi| |
7. Update System | Enter - F1=Help - Esc=Quit |
8. Display Error | --------- ------------ --------- |
9. View or Set Vi+------------------------------------------+
10. Manipulate Dead Man Timer
11. Remote Initial Program Load Setup
12. Change Management
13. Prepare Hard Disk
Enter
- Esc=Quit - F1=Help -
----------- -------------- -------------
ˆ ˜
Figure 4-8. Set Supervisory Password Panel
3
Type the password again and press Enter.
4
The Password Saved panel is displayed with the message that your
supervisory password has been saved.
4-10
2216 Maintenance Manual