IBM Nways 2216, Service And Maintenance Manual

Page: 52 / 168

19
Reach inside the 2216, grasp the bottom middle of the backplane’s plastic shield, and press it up
and toward you until all the bulkhead screws protrude through the chassis.
20
Loosely insert the remaining screws on each side.
21
Install and tighten the eight nuts and star washers inside the 2216 that secure the backplane to the
system.
22
Tighten the screws along the side of the box that hold the backplane in place.
23
Replace the top of the unit.
a
Align the five tabs on the top panel with the slots on the top front of the 2216.
b
Lower the top, and then press it back into place.
c
Reinstall the middle screw on each side.
24
Reinstall and tighten the three screws that secure the top of the box to each side of the box.
25
Mount the 2216 in the rack. It is recommended that you use a screw starter here.
a
If you have a shelf, install it in the rack first. Otherwise, install the installation aid.
b
Slide the 2216 into the rack.
c
While one person holds the box in place, the other should install the bottom screw into each
mounting bracket. Then install the remaining six screws.
2-22
2216 Maintenance Manual