IBM Nways 2216, Service And Maintenance Manual

Page: 57 / 168

SLIP Addresses
The default SLIP IP addresses are:
For the workstation:
10.1.1.3
For the IBM 2216:
10.1.1.2
For instructions about installing SLIP, refer to the documentation for your version of
TCP/IP.
Serial Port and PCMCIA Modem Default Settings
These are the default settings for the serial port:
Speed 19.2 Kbps
Parity None
Data Bits 8
Stop Bits 1
The PCMCIA modem is a standard item that is shipped with the IBM 2216. The
modem is a 33.3 Kbps V.32 bis modem. It is set up with a default speed of
auto-detect. The parity, data bits, and stop bits are the same as those of the serial
port: None, 8, and 1.
Attaching an ASCII Terminal
Attach an ASCII terminal or emulator (with the appropriate emulation software) to
provide local or remote access to the 2216 as shown in Figure 3-1 on page 3-2
and Figure 3-2 on page 3-2.
The DEC VT100 ASCII terminal is supported, as well as devices such as personal
computer systems that are configured to emulate it. Configure a VT100 with:
¹
No parity
¹
8-bit word length
¹
1 stop bit
¹
300 bps–38.4 Kbps bit rate
Note: The speed must match the speed of the connected terminal. It is 19.2
Kbps if the serial service port is used, any speed if the PCMCIA modem is
used and is set to autobaud.
ASCII Terminal Setup Attributes
This is a list of all the options required to set up a terminal for use with the IBM
2216 that is connected to the service port. Not every terminal (particularly 3151
and 3161) will have all these options. You should use the information to set the
options that you can set on your terminal.
Chapter 3. Accessing the 2216
3-3