IBM Aptiva 2134, Hardware Maintenance Service

Page: 74 / 266

Table 2-1 (Page 11 of 25). POST and Diagnostics and Utilities Index
for Symptoms, Messages, Error Codes, or Beeps
Symptoms, Messages, Error
Codes, or Beeps Action/FRU
Program loads from the hard
disk with a known-good CD in
the CD-ROM drive or diagnostics
diskette in the first 3.5-inch
diskette drive (and CD-ROM
drive or diskette drive is enabled
in the Setup Utility). “Factory-Installed Drive Devices” on
page 2-46.
CD-ROM Drive
Diskette Drive
System Board
Power Supply
Program or File
Not Found
Press Any Key
Diagnostics cannot find the
USER(N).COM file.
Diagnostic CD or diskette
CD-ROM Drive or Diskette Drive
System Board
Program Too Big To Fit In
Memory.
Too many Terminate and Stay
Resident programs in memory. Reboot the system from the Diagnostic CD.
System unit does not turn off
with power switch. (System unit
must be unplugged from
electrical outlet to completely
turn off.) “Power Supply” on page 2-35
Power switch assembly
System Board
QAPlus/PRO Cannot Be Re-run
Because Of Error In Relocating
Program.
Diagnostics failed to relocate the
Diagnostics Test programs so
the memory space it resides in
was not tested. Diagnostic CD
Memory Module
System Board
RAM Memory Error in Block n.
Bad bits n.
Memory error. Memory Module
System Board
RAM Test Failed.
Memory error. Memory Module
System Board
Read error on cylinder n.
Hard disk drive format error. Hard Disk Drive
System Board
Read Errors
Diskette drive read error. Diskette
Diskette Drive
System Board
Diskette Drive Cable
2-20