IBM Aptiva 2134, Hardware Maintenance Service

Page: 70 / 266

Table 2-1 (Page 7 of 25). POST and Diagnostics and Utilities Index
for Symptoms, Messages, Error Codes, or Beeps
Symptoms, Messages, Error
Codes, or Beeps Action/FRU
Incorrect memory size shown or
repeated during POST. “Memory” on page 2-38.
Invalid Time
Clock/DOS time mismatch.
Back-up clock and DOS time of
day settings do not match. RTC Battery
System Board
Joystick does not respond at all. 1. Ensure the joystick is plugged
completely into the joystick/MIDI
adapter plug on the Mwave card or the
sound adapter card and secured with
the screws on the adapter plug.
2. Verify that the software application
used with the joystick has joystick
support.
3. Ensure the joystick is enabled in the
software application. This might
require entering keystrokes or a
configuration utility in the software
application.
If the above steps find no problem, see the
“Joystick does not work correctly” symptom
below.
Joystick does not work correctly
(installation is correct—see
above symptom). 1. Disable the joystick in the software
application.
2. Enable the mouse as the input device
in the software application.
3. If the mouse works in the software
application, replace the joystick. If the
symptom remains, replace the Mwave
card or the sound adapter card.
4. If the mouse does not work, check the
software application troubleshooting
information provided by the
manufacturer.
Linear Cylinder Access Test
Failed.
Hard disk drive error. Hard Disk Drive
Hard Disk Drive Cable
System Board
Logic Function Failed.
CPU Logic test error. Processor
System Board
2-16