IBM Aptiva 2134, Hardware Maintenance Service

Page: 77 / 266

Table 2-1 (Page 14 of 25). POST and Diagnostics and Utilities Index
for Symptoms, Messages, Error Codes, or Beeps
Symptoms, Messages, Error
Codes, or Beeps Action/FRU
The Address Exceeds The Size
Of Your Memory.
An invalid memory address was
entered. The Diagnostics Tests
display this message during the
Locate Bad Chips option under
the interact menu if an invalid
memory address was entered at
the "Enter Memory Address Of
Bad Chip" prompt. Enter correct address
Memory Module
System Board
That Number is Out Of Range.
An invalid bit number was
entered. Diagnostics Tests
display this message during the
Locate Bad Chips option. Enter the correct number.
Memory Module
System Board
Too Many Errors - Test Aborted.
Too many errors, the Diagnostics
Test cannot continue. Processor
System Board
Transmit Error.
Internal or external serial port
loopback test failure. Serial Port Cable System Board
TV card failures “TV Card” on page 5-15
Video Adapter Failed.
Test Result Summary, displayed
if "Fail" was at the Quit/Fail/Pass
menu of any video test. Video Adapter
System Board
Display
Wake Up on Ring feature fails to
power-on system when enabled
in Setup Utility. Mwave Wake Up on Ring jumper
connection/cable
Mwave card
“28.8 Kbps DSVD Factory-Installed Modem
Adapter” on page 2-62, if installed.
System Board
When you try to enable or
disable Rapid Resume, Rapid
Resume configuration screen is
not available. System Board
Write error on cylinder n.
Hard disk drive write error. Hard Disk Drive
Check Procedures
2-23