IBM Aptiva 2134, Hardware Maintenance Service

Page: 62 / 266

(continued)
013 (continued)
– Make note of any messages, error codes, beeps, or new symptoms.
Go to “Index of Symptoms, Messages, Error Codes, or Beeps” on
page 2-9.
014
– The Easy Test Diagnostics did not detect a failure. If the system still
displays a failure:
Check all adapter card jumper settings.
Check all adapter card switch settings.
Check all adapter card cables and connectors for proper installation.
Make sure all of the above are set correctly and show the correct
voltages and continuity. Replace any defective cables or adapter
cards. See “Power Supply” on page 2-35, “System Board
Layout—Type A-1” on page 5-2, and “System Board Layout—Type
A-2” on page 5-5.
– Run the Easy Test Diagnostics again.
– If an error or other symptom is displayed, go to “Index of Symptoms,
Messages, Error Codes, or Beeps” on page 2-9.
– If no error can be detected or the symptom is intermittent, go to
“Undetermined Problem” on page 2-70.
2-8