IBM 6219 - IntelliStation M - Pro, Hardware Maintenance Manual

Page: 103 / 154

Error code/symptom FRU/action
00180200
(No more I/O space available for PCI
adapter.)
1. Run the Configuration/Setup Utility program.
2. Adapter.
3. System board.
00180300
(No more memory above 1MB for PCI
adapter.)
1. Run the Configuration/Setup Utility program.
2. Adapter.
3. System board.
00180500
(PCI option ROM checksum error.)
1. PCI adapter
2. System board
00180600
(PCI device BIST failure. PCI bridge error.)
1. Run the Configuration/Setup Utility program.
2. Adapter.
3. System board.
00180700
(PCI device no responding.)
1. System board
2. PCI adapter
00181000
(General PCI error)
v Adapter
v System board
I9990650
(AC power has been restored)
1. Check cable.
2. Check for interruption of power.
3. Power cable.
POST (ISPR) error procedures
Use the ISPR error procedures to help you solve ServeRAID problems. A complete
list of error codes is listed at “ServeRAID error codes” on page 95.
Note: Where the ISPR Error Procedures refer to a hard disk drive backplane, see
the chapter of this publication that concerns field replaceable units.
EF10 (Default ISPR)
1. No ISPR error present.
9 ZXX thru B ZXX (SCSI bus error caused by cables, termination, or defective
drives.)
1. Isolate the SCSI subsystem from the controller by disconnecting all hard disk
drive cables from the suspect adapter, and restart the computer.
CAUTION:
Do not press F5. Doing so changes the configuration of the server.
If an ISPR error is still present, perform the following actions until the error is no
longer present:
a. Reseat the controller
b. Replace the controller
Notes:
a. SCSI channel cable details, if any, appear elsewhere in this publication.
b. The adapter/controller detects a configuration change. Do not select Save
Changes . Instead, press F10 to bypass any options to this effect.
2. If ISPR error is EF10 after disconnecting cables:
Symptom-to-FRU index
93