IBM 2027-R04, Installation And Service Manual

Page: 44 / 116

SAN16M-R SAN Router Installation And Service Manual 20
This section described how to perform the basic set up procedures.
To set the SAN Router IP address, you can connect a terminal to the
RS-232 port on the SAN Router or access the SAN Router via Telnet
or embedded Web-based management on the 10/100 management
port using the default management IP address.
Task 5: Connecting the VT100 or emulation terminal to the
RS-232 management port
To connect the terminal:
1. Use a null modem cable to connect a VT100 terminal or any
standard PC running terminal emulation software to the RS-232
serial port on the SAN Router. (See
Figure 4,
Management port to
management terminal connection
, (1).) This connection does not
require an IP address. You also set the 10/100 Ethernet
out-of-band management address from here.
• Connect female end of cable to the RS-232 port on the SAN
Router.
• Connect the male end of the cable to the RS-232 port on the
terminal.
Auto Reset on Severe Errors Enabled
Fast Write Off
Serial Port 9600, 8, none,1, none
Table 9
Other defaults
Parameter Default Setting