IBM 2027-R04, Installation And Service Manual

Page: 43 / 116

19 Chapter 2: Installing and connecting the SAN Router
Task 4: Preparing to configure the SAN Router
You must first change the Management Port IP address through the
CLI as described in
Task 5: Connecting the VT100 or emulation terminal
to the RS-232 management port
on page 20 and
Task 6: Preparing the SAN
Router for Element Manager access
on page 21.
Table 8 and Table 9 list and describe the default settings for the IP
SAN Router.
Refer to Table 8 for the default setting for the Management Port IP
address, which is the only IP address that must be changed using CLI
to provide access for out-of-band management. All other default
setting can be changed using the Element Manager.
For a complete list of default values, review
SAN Router firmware
default values
on page 32
Table 8 Default management and SAN Router addresses
Port IP Address Subnet Mask Default Gateway
Mgmt 192.168.100.100 255.255.255.0 0.0.0.0
Table 9
Other defaults
Parameter Default Setting
Zoning No Zone (No devices zoned by default)
iFCP SAN ID 0
FC Port Type FC - Auto
Intelligent Port Interface Depends upon the configuration purchased.
Intelligent Port Type Depends upon the configuration purchased.
E_Port Zone Policy Append router zones
Compression Off
MTU Auto