Manual
ibaBM-DP
68
Issue 1.7
Fig. 38: Digital signals on bus 1
10.3 Modules in I/O Manager
If you want to use ibaBM-DP with ibaPDA, you have to configure the device in the ibaPDA
I/O Manager. Use the step-by-step procedure described in chapter 10.1. If necessary
consider the notes on the compatibility mode 32Mbit in chapter 10.2.
In the following chapters, the device module "ibaBM-DP" as well as the modules "Active
slave", "Sniffer", "Active slave decoder", "Sniffer decoder", “Slave diagnostics” and “Bus
diagnostics” are described.
Note
In the following chapters, the modules are described the way they are used on the input
side of ibaPDA (data acquisition). In chapter 10.7 we describe how data can be sent from
ibaPDA over ibaBM-DP to the PROFIBUS.
10.3.1 "ibaBM-DP" device module
The device module "ibaBM-DP" disposes of 6 different tabs. The "General", "Diagnos-
tics", "PROFIBUS Browser" and “Event log” tabs are always available. The "Analog" and
the "Digital" tab contain dynamic online views of the analog and digital signals acquired
by the device. This is why these two tabs are only visible after modules have been added
and the configuration has been transferred to the device.
