Manual
ibaBM-DP
48
Issue 1.7
Note
You can deactivate the slave with the checkbox „Active“.
Fig. 24: Setting the slave address
In the example (see figure above), the first slave with the PROFIBUS address 10 is ac-
tivated on bus 0, the second slave with the address 20 is activated on bus 1. The FO
interface is set to „0: PDA 32 Integers“ mode. This means, that each of both slaves has
an output range for 32 analog signals (Integer) and 32 digital signals. The data is trans-
ferred via the FO interface to e.g. ibaPDA.
The settings are stored in the device by clicking the button <Submit>.
The display of the settings is updated by clicking the button <Refresh>.
For further information about DP-64 mode, please see chapter 13.
9.3.4.2 P2P mode
In the P2P mode, the following settings can be configured in the “Settings” mask:
Transmission Mode
The P2P mode uses the 32Mbit ibaNet protocol. In the transmission mode field, you
define how this protocol is assigned. You can choose from the following transmission
modes:
4: 1024 I 1024 Digital in 800µs
A: 512 Real + 512 Digital in 800µs
C: 2872 bytes in 1000µs
The setting has to correspond with the setting in the 32Mbit communication partner (e.g.
ibaLink-VME).
For each slave: bus number, address and active
The data from the ibaNet telegrams are mapped in send and receive direction on up to
8 slaves (A - H). For each slave, you can choose, on which bus it is to be activated, which
PROFIBUS address should be assigned and if you want to use this slave at all.
