ibaBM-DP
Manual
Issue 1.7
17
6
Mounting and dismounting
6.1
Mounting
1.
Insert the DIN rail clip on the rear side of the device on top in the DIN rail, press the
device down/back and let the DIN rail lock.
2.
If there is the provision in the plant that the device has to be grounded, then con-
nect the device to the ground (shield connector X29).
3.
Once fixed, connect the 24 V DC power supply with the right polarity and establish
the connection as follows:
FO to the ibaPDA system (unidirectional or bidirectional depending on the mode
of operation)
Network connection via Ethernet TCP/IP (in compatibility mode 32Mbit)
Connecting the PROFIBUS cable
Do not connect the PROFIBUS cable until the configuration of the “Active slaves“ has
been done correctly.
Please see also chapter 11.2.
6.2
Dismounting
1.
First of all, disconnect all connections that exist to the device.
2.
Grasp the device with one hand firmly on the top side. For the device later lies firmly
in your hands and does not fall to the floor, please press the device slightly down.
3.
With the other hand, grasp the device on the bottom and pull it to the front/top. The
device will get detached from the DIN rail.
