IAI EYECYLINDER EC-B6 Series, Instruction Manual, Page: 58 / 204

2.3 Installation of belt type
2-6
2. Installatio
n
Precautions regarding stainless steel sheet
● During installation and transport, do not grasp or press on the stainless steel sheet.
Otherwise, this may lead to stainless steel sheet damage.
● There may be a case that slackness or misalignment occurs on the stainless steel sheet.
Installation in horizontally oriented wall mount and in ceiling mount especially could cause
slackness or misalignment on the stainless steel sheet.
Continued usage in this orientation may lead to damage to the stainless steel sheet.
● Adjust the stainless steel sheet if slackness or misalignment occurs.
● Keep adhesive, paint, and other viscous material off the stainless steel sheet.
Such material adhering to the stainless steel sheet can lead to defective slider operation or
sheet damage.
Avoid installation in environments of this kind, or take safety measures to prevent adhesion.
Fixing bolt
● The bolts and positioning pins for fixing are to be prepared by the customer.
● The use of high-strength bolts of ISO-10.9 or higher is recommended.
● Make sure the internal thread and bolt effective engagement length is approximately 1.8 times
the nominal diameter or more.
● When the tightening torque is not specified, tighten with the torque in the table below.
For installation, tighten the bolts referring to ‘When the bolt setting surface is aluminum’.
Fixing bolt
Tightening torque
When the bolt seating
surface is steel
Tightening torque
When the bolt seating
surface is aluminum
M4
3.59N•m 1.76N•m
M5 7.27N•m 3.42N•m