Hypertherm Edge TI, Manual

Page: 406 / 574

Sensor™ THC 382
Press the Timing Diagram soft key to view the timing diagram from setups.
Retract Delay
The Retract Delay Parameter is used to specify the amount of time delay that the used between the
cut off and the torch retract.
Auto Voltage Set
When enabled, the Auto Voltage Set feature is used to sample the Arc Voltage being generated when
cutting at a specific cut height. Then the Arc Voltage value relative to the manual cut height sample
will be used when cutting the part instead of a predetermined Arc Voltage.
Set Arc Voltage
The operator may input the desired Arc Voltage for the material being cut.
Cut Height
The Cut Height setup parameter is used to select the desired cut distance from the plate. This will set
the initial cut height before arc voltage control is activated when operating in automatic mode.
Pierce Height
The Pierce Height setup parameter is used to select the desired Pierce Height. This may be entered
as a multiplication factor that is calculated times the Cut Height or an actual Pierce Height distance.