HYOSUNG GT650 - PARTS CATALOGUE, Owner'S Manual

Page: 38 / 102

37 37
● ●
Take off the starter switch right after
started.
● ●
Do not engage the starting motor for
more than five seconds at a time as it
may overheat the wiring harness and
starting motor.
If the engine does not start after sev-
eral attempts, check the fuel supply
and igintion system.
(Refer to Page 88)
CAUTION
The
『 『 』 』
are equipped
with the side stand ignition interlock
system.
If the transmission is in neutral or the
side stand up, you can only start the
engine with pulling in the clutch lever.
This side stand ignition interlock system
prevents the motorcycle from being
started with side stand down.
Make sure that the side stand igintion
interlock system is working properly
before riding.
WARNING
These motorcycles always come on the
head lamp, position lamp, meter lamp,
tail lamp and license plate lamp when
the ignition switch was turned to the
“ON” position.
CAUTION
⑤ ⑤
STARTER SWITCH
Use this switch to operate the starting
motor.
With the ignition switch in the “ON” posi-
tion, the engine stop switch in the “ ”
position, and the transmission is in neutral,
squeeze the clutch lever and the side stand
up and push the starter switch to start the
engine.
N O T E
Push the starter switch after about three
seconds whenever the ignition switch is
set to “ON” position with engine
stopped as a test of the electric injection
system operation.
If push the starter switch before about
three seconds, the engine will be started
badly and the spark plugs get wetted.