HYOSUNG GT650 - PARTS CATALOGUE, Owner'S Manual

Page: 72 / 102

71
5. Check the electrode gap with a thickness
gauge. The gap must be 0.7 ~ 0.8 mm
(0.028 ~ 0.032 in) if necessary, adjust it.
6. Make sure that the washer is in good
condition. Fit the washer and screw the
spark plug finger-tight to avoid damaging
the thread.
7. Tighten using the spanner supplied with
the tool kit. Screw in each spark plug by
one half turn to compress the washer.
0.7 ~ 0.8 mm
(0.028 ∼ 0.032 in)
TIGHTENING TORQUE
SPARK PLUG
11 N
·
m
(1.1 kgf
·
m)
PLUG REPLACEMENT GUIDE
Hotter type
Standard type
Colder type
CR7E
CR8E
CR9E
The spark plug must be tightened firmly,
otherwise the engine may overheat and
severe damage may occur.
Use recommended spark plugs only. A
spark plug of the wrong rating may
shorten engine life and cause loss of
performance.
CAUTION
8. Fit the spark plugs cap properly, to pre-
vent it coming off due to engine vibration.
ting into the engine. Change the spark
plugs if it shows cracks on the insulating
material, corroded electrodes or exces-
sive deposits.